Filter
Top Products
Combination mode
380
CC Number [Off, MIDI CC#00…CC#95]
Value [000…127]
▼ 7–2: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy KARMA Module. For more information,
see “Copy KARMA Module” on page 408.
• 3: Initialize KARMA Module. For more
information, see “Initialize KARMA Module” on
page 409.
• 4: Copy Scene. For more information, see “Copy
Scene” on page 409.
• 5: Swap Scene. For more information, see “Swap
Scene” on page 409.
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 409.
• 7: Copy From Program. For more information, see
“Copy From Program” on page 405.
7–3: Module Parameters-Control
Here you can set KARMA Module Control parameters.
In Combination mode, four KARMA Modules ([A],
[B], [C], [D]) can be used.
7–3a: Module Parameter-Control
Control
Transpose [–36…+36]
Force Range [Off, Lowest, Highest,
C3-B3[1], C3-B3[2]]
Force Range Wrap [C#…C]
Root Position [Off, On]
Please see “Control” on page 103.
Timbre Zone Bypass [Off, On]
Specifies whether the key zone settings (3–5) and
velocity zone settings (3–6) of the timbre will be
applied to the phrase or pattern generated by the
KARMA Module.
On (checked): The key zone settings and velocity zone
settings of the timbre will be bypassed for the phrase
or pattern generated by the KARMA Module. The
settings of the timbre will be ignored, and the notes
generated by the KARMA Module will be sounded.
Off (unchecked): The key zone settings and velocity
zone settings of the timbre will be applied to the
phrase or pattern generated by the KARMA Module.
Notes generated by the KARMA Module will not be
sounded if they are outside the key zone or velocity
zone of the timbre.
1–1a
7–3a
7–3PMC