Filter
Top Products
Sequencer P8: Insert Effect 8–5: Insert FX
515
8–5: Insert FX
8–5a: IFX
Here you can choose the type of each insert effect 1
through 12, its on/off status, chaining, and adjust the
post-IFX mixer settings. For insert effects, the direct
sound (Dry) is always stereo-in and out. The
input/output configuration of the effect sound (Wet)
depends on the effect type. For descriptions of the
individual effects, please see “Effect Guide,” beginning
on page 727.
The following parameters are the same as in Program
mode. For details, see “8–5b: IFX” on page 127.
However, unlike in Program mode, insert effect
dynamic modulation (Dmod) and the post-IFX Pan
(CC#8), Send1, and Send2 are controlled on the MIDI
channel specified by “Ch” (8–7a). The control changes
used are the same as in Program mode.
The pan (CC#8), send 1 and 2 settings you make here
will be used when the song is played or recorded from
the beginning. If you change the settings while
recording a MIDI track, the changes will be recorded as
part of the musical data, and the settings will change
when the data is played back. You can also change
these settings during playback. However if pan
(CC#8), send 1, or 2 data has been recorded, the
settings will change accordingly.
If Status (2–1a) is either INT or BTH, CC#8, CC#93,
and CC#91 can be received to control the pan
following the insert effect, send 1, or send 2
respectively, and change their settings. When you
switch songs or return to the beginning of the song,
tracks whose Status is BTH, EXT, or EX2 will
transmit these settings via MIDI. This data will be
transmitted on the MIDI channels specified in the
IFX 1–12 pages (8–7).
IFX1
IFX1 [000…185]
IFX1 On/Off [Off, On]
Chain to [IFX2…IFX12]
Chain [Off, On]
Pan(CC#8)
(Post IFX PanCC#8)
[L000…C064…R127]
Bus Sel. (Bus Select) [L/R, 1…8, 1/2…7/8, Off]
Ctrl Bus (FX Control Bus) [Off, 1, 2]
REC Bus [Off, 1, 2, 3, 4, 1/2, 3/4]
Send1 [000…127]
Send2 [000…127]
Note: You can use the control surface to control Send 1
and 2. For more information, please see “Send1
(MFX1)” on page 394.
IFX2…12
These parameters specify the type of each insert effect,
its on/off status, chaining, and post-IFX mixer settings.
With the exception of Chain to and Chain, the
parameters are the same as for IFX1. For more
information, please see “IFX1” on page 127.
1–1b
8–5a
8–5PMC8–5b