Filter
Top Products
EXi: CX-3 Tonewheel Organ
226
Program P7: Amp, V/C, Rotary Speaker
7–1: Amp & V/C
7–1a: Amp
Amp Type [Type 1, Type 2, Pre Amp]
This selects the type of amp model.
Type 1 is a standard powered amp for organ,
producing a warm, fat tone.
Type 2 emphasizes the high range more than Type 1,
producing a less colored tone.
PreAmp is the sound of a direct line-out from the
organ.
Amp Gain [00…99]
This adjusts the gain when Amp Type is set to Type 1
or Type 2.
Expression also adjusts the drive into the Amp section.
With higher Amp Gain settings, you’ll get more
overdrive and distortion as you increase the
Expression amount. For more information, see “4–2b:
Expression,” on page 217.
This setting does not apply if the Amp Type is set to
PreAmp.
AMS [List of AMS Sources]
This selects an AMS source to modulate the Amp
Gain. For a list of AMS sources, see “AMS (Alternate
Modulation Source) List” on page 967.
Intensity [-99…+99]
This controls the depth and direction of the AMS
modulation of Amp Gain.
7–1b: EQ
Treble [-10…+10]
This adjusts the high frequency range of the amp, as
selected by Amp Type.
Mid [-10…+10]
This adjusts the mid-frequency range of the amp, as
selected by Amp Type.
Bass [-10…+10]
This adjusts the low frequency range of the amp, as
selected by Amp Type.
7–1c: Vibrato/Chorus
Vibrato/Chorus is a traditional organ effect, similar to
but not the same as other chorus effects. It adds
varying degrees of LFO-driven flutter and richness to
the timbre, and combines nicely with the rotary
speaker.
In addition to the six traditional presets, the CX-3
allows you to create your own custom settings, which
can then be modulated via AMS.
There is a single Vibrato/Chorus effect, and each set of
drawbars can either be routed through the effect or go
straight on to the rotary speaker and outputs.
Upper Drawbars V/C [Off, On]
This routes the upper drawbars through the
Vibrato/Chorus.
7–1PMC
7–1b
7–1a
7–1c
7–1d
7–1e
7–1f