Filter
Top Products
Combination P1: EQ/Vector/Controller 1–6: Vector CC Control
353
–X [Off…MIDI CC#119]
This assigns the controller sent by the –X vector. It will
be grayed out if the VJS X Mode, above, is set to
Positive.
The selections are the same as for +X, above.
VJS Y Mode [Positive, Negative, Xfade, Split]
This controls the Vector CC pattern for the Y axis. For
more information, see the description under VJS X
Mode, above.
+Y [Off…MIDI CC#119]
This assigns the controller sent by the +Y vector. It will
be grayed out if the VJS Y Mode, above, is set to
Negative.
The selections are the same as for +X, above.
–Y [Off…MIDI CC#119]
This assigns the controller sent by the +Y vector. It will
be grayed out if the VJS Y Mode, above, is set to
Positive.
The selections are the same as for +X, above.
Show Point [VJS, Vector EG Point 0…4]
You can view the volume and CC values for the
current position of the Vector Joystick, or for any of the
EG’s five points. This selects the point whose values
will be shown.
CC at Show Point [%]
This read-only display shows the volume values for
the current Vector point, as selected by the Show Point
parameter, above.
Timbre 01
Enable Combi Vector CC [Off, On]
This controls whether or not the Timbre will receive
the Combi Vector CCs.
If this is On, the Timbre will receive the CCs, and the
Timbre’s Program will respond to them according to its
own AMS settings.
If this is Off, the Timbre will not receive the CCs. This
can be useful if the Combi’s Vector CCs are causing
unwanted modulation, or conflicting with the
Program’s own Vector CCs.
Enable Program Vector CC [Off, On]
This controls whether or not the Program’s own Vector
CCs will be active.
If this is On, the Program’s Vector CCs and Vector EG
will work as AMS sources, just as they did in Program
mode. The CCs will not affect any other Timbres, even
if they are set to the same MIDI channel.
Note that. in some cases, the Vector CCs may have
been used for modulating the Program’s effects via
Dmod. This functionality is not carried into the Combi;
for modulating the Combi effects, use the Combi’s
Vector CCs instead.
If Enable Program Vector CC is Off, then the
Program’s Vector CCs will have no effect. This can be
useful if they are conflicting with the Combi’s Vector
CCs.
Timbres 02–16
The settings for Timbres 2–16 are identical to those for
Timbre 01, as described above.
▼ 1–6: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy From Program. For more information, see
“Copy From Program” on page 405.