Filter
Top Products
Program mode: HD-1
134
Program P9: Master/Total Effect
Here you can make settings for the master effects and
total effects. For instance, you can:
• Route a sound to an master effects and total effects
• Make detailed settings for master effects and total
effects
For more information, please see “Effect Guide” on
page 727.
9–1: Routing
Here you can specify the type of master effects and
total effects, and turn them on/off.
The master effects are sent to the L/R bus. The total
effects are inserted into the L/R bus.
9–1a: MFX1, 2
The master effect does not output the direct sound
(Dry). Adjust the “Return 1” and “Return 2” return
levels to return the signal to the L/R bus and mix it
with the L/R bus signal.
The master effects are stereo-in/out, but depending on
the selected effect type, the output may be monaural.
See “In/Out” on page 734.
MFX1
MFX1 [000…185]
This selects the effect type for master effect 1. You can
use any of the available effects, without limitation. If
you choose 000:No Effect, the output from the master
effect is muted.
Category/MFX Select menu
When you press the popup button, the Category/MFX
Select menu will appear, letting you select effects by
category. Use the tabs to select a category, and then
select an effect within that category. Press the OK
button to execute your selection, or press the Cancel
button to cancel.
MFX1 On/Off [Off, On]
Switches the master effect 1 on/off. When off, the
output will be muted. This will alternate between on
and off each time it is pressed.
Separately from the settings here, you can use
control change #94 to turn master effects 1 and 2 off.
A value of 0 turns them off, and values of 1–127
restore the original setting. The global MIDI channel
specified by MIDI Channel (Global 1–1a) is used
for this message.
Return 1 [000…127]
This specifies the return level from the master effect to
the L/R bus (after which it passes through TFX1 and 2,
and is sent from L/MONO and R).
9–1PMC8–5b
9–1a
1–1a
9–1b
9–1c