Filter
Top Products
Program: Page Menu Commands Copy Tone Adjust
143
Automatically-set parameters and their values
- : Not set automatically
Values enclosed in parentheses ( ) are automatically set
according to the settings you make in the dialog box.
*1: Settings for Analog, S/P DIF (“Input 1” and
“Input 2”) are made automatically.
*2: The input source setting (“Input 1” and “Input
2”) you specified for “Source Audio” in the dialog
box will be set automatically.
*3: If “Source Audio” is Mono-L this will be L-
Mono, if Mono-R this will be R-Mono, and if Stereo
this will be Stereo.
*4: When “Save to: RAM,” and “Convert to
Program” is checked.
Copy Tone Adjust
Copy Tone Adjust is available on the Control Surface
page when CONTROL ASSIGN is set to TONE
ADJUST.
This command replaces the current Tone Adjust
settings with those of any other Program, Combination
Timbre, or Song Track.
1. Select “Copy Tone Adjust” to open the dialog box.
2. Use “From” to select the copy-source mode, bank,
and number.
You can use the front-panel BANK keys to select the
desired bank.
3. In the Timbre field (if you’ve selected a
Combination) or Track field (if you’ve selected a
Song), select the Timbre or Track to copy from.
4. Select either All or Assignments Only to specify
the Tone Adjust parameters you want to copy.
All: This copies both the Tone Adjust parameter
assignments and values.
Assignments Only: This copies only the Tone
Adjust parameter assignments, without the values.
5. Press the OK button to execute the Copy Tone
Adjust command, or press the Cancel button if
you decide to cancel.
Reset Tone Adjust
Reset Tone Adjust is available on the Control Surface
page when CONTROL ASSIGN is set to TONE
ADJUST.
This command resets the Tone Adjust settings for all of
the Knobs, Switches, and Sliders to their default
values.
1. Select “Reset Tone Adjust” to open the dialog box.
2. Use the “To” field to specify how the Knob 1–8,
SW1–16, Slider 1–8, and Master Slider parameters
will be reset.
All Off: All will be reset to Off.
Default Setting: The parameters will be reset to the
default values for the applicable type of program
(HD-1, AL-1, CX-3).
Parameter
1.
Initialize
2.REC
Audio
Input
3.Auto
Resampl
e
through
IFX
Input (Input Source) :
Analog,
S/P DIF
*1
(Source
Audio)
*2
Analog,
S/P DIF
*1
Input1 :
Level 127
Pan L000
Bus Select Off (IFX)
*3
Off
Send1 000
Send2 000
Input2 :
Level 127
Pan R127
Bus Select Off (IFX)*
3
Off
Send1 000
Send2 000
Recording
Setup :
Source Bus L/R
Trigger Sampling START SW
Metronome
Precount
Off – –
Resample Manual Manual Auto
REC
Sample
Setup :
Save to RAM (Save to) (Save to)
Sample
Mode
L–MONO
(Source
Audio)
*4
Stereo
Sample
Time: RAM
Maximum – –
Sample
Time: DISK
4min
59.999se
c
––
Recording
Level [dB]
+0.0 +0.0 –12.0
REC
Sample
Preference :
Auto
+12dB On
Off Off On
Bus Select
(P8 Routing)
:
All OSCs to L/R L/R (IFX)