Filter
Top Products
Effect Guide
742
Audio Input, S/P DIF IN
In Program, Combination, Sequencer, and Disk modes,
external audio sources from the AUDIO INPUT 1, 2, 3,
4, and S/P DIF IN jacks can be processed by insert
effects, master effects, and total effects just as they can
in Sampling mode.
You can sample while applying the OASYS’s effects to
the external audio sources from these jacks, or use the
OASYS as a 6-in (AUDIO INPUT 1, 2, 3, 4, S/P DIF IN
L, R) 10-out effect processor. You can also use an
external mic input to control a vocoder effect (026:
Vocoder) applied to internal sounds.
In Sequencer mode you can also use the effects when
recording external audio sources to audio tracks.
In each mode, use “Audio Input” (P0– Audio
Input/Sampling page) to make settings for external
input from the AUDIO INPUT 1, 2, 3, 4, and S/P DIF
IN jacks. Alternatively, you can check Use Global
Settings and use the Global mode “Audio” settings.
Set Bus Select to specify the bus to which the external
audio input will be sent. You can select L/R, IFX1–12,
1–8, 1/2–7/8, or Off. If you want to apply an insert
effect, select IFX1–12.
Send1 (to MFX1) and Send2 (to MFX2) become
effective only when Bus Select is set to L/R or Off. If
IFX1–12 is selected, use P8: Insert Effect page Send1
and Send2 for the post-IFX signal.
The diagram (Fig. 2–4a) shows an example in which
the input from INPUT 1 and 2 is panned to left and
right, and sent to insert effect 1.
In Disk mode, effects will use the settings of the
mode in which you previously were.
Fig. 2–4a