Filter
Top Products
Combination P7: KARMA 7–6: Perf Real-Time Parameters
385
duration setting. If you disconnect the Master Layer,
the duration value indicated by the Module Layer will
be sent out. You can adjust the Module Layer’s
Duration % (Gate) control to sound the same at that
point, if desired.
Turning “Enable RTC By Master” back on will resend
the Master Layer’s duration setting, if it was the last
moved control connected to the duration in that
Master Scene.
▼ 7–5: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy KARMA Module. For more information,
see “Copy KARMA Module” on page 408.
• 3: Initialize KARMA Module. For more
information, see “Initialize KARMA Module” on
page 409.
• 4: Copy Scene. For more information, see “Copy
Scene” on page 409.
• 5: Swap Scene. For more information, see “Swap
Scene” on page 409.
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 409.
• 7: Copy From Program. For more information, see
“Copy From Program” on page 405.
7–6: Perf Real-Time Parameters
Here you can assign controllers to KARMA
Performance Real-Time Parameters (Perf. RTP) outside
of the GE Real-Time Parameters that control the
internal settings of the GE. Examples include the
KARMA Key Zone parameters (Combination 7-1b)
and KARMA Control and Trigger parameters
(Combination 7-3, 7-4).
For more information, please see “7–6: Perf Real-Time
Parameters” on page 385.
7–6a: Perf Real-Time Parameters (1…8)
Group [Off, PE, Mix, Control, Trigger,
Key Zones, Random Seeds]
Parameter [---, Time Signature…
Retrigger Each Time]
Min (Minimum Value) [–8192…+8191]
Max (Maximum Value) [–8192…+8191]
Value [–8192…+8191]
For more information on these parameters, see “7–6b:
Perf Real-Time Parameters” on page 112.
1–1a
7–6a
7–6PMC