Korg Electronic Keyboard Electronic Keyboard User Manual


  Open as PDF
of 1127
 
Sampling P4: EQ/Controller 4–1: EQ
595
Sampling P4: EQ/Controller
In this page you can edit a mid-sweepable three-band
EQ that is applied to the output of the multisample.
You can also assign the functions of the SW1 and SW2
switches and Modulation 5–8 knobs, and the note
number and velocity that are produced by pads 1–8.
4–1: EQ
Here you can edit the mid-sweepable three-band EQ
that is applied to the output of the multisample.
4–1a: 3 Band Parametric EQ
In addition to editing these parameters in the screen,
you can use the control surface to edit all EQ
parameters other than “Bypass.” These can also be
controlled from the mixer section of the front panel, or
from the P0– Control Surface page of the LCD screen.
Here’s the procedure for editing these settings from the
front panel.
1. Press the CONTROL ASSIGN MIXER
TIMBRE/TRACK switch to make 1–8 light.
2. Press the MIXER KNOBS switch to make
CHANNEL STRIP light.
3. Use the MIX CHANNEL STRIP knobs 2–6 to
control “EQ TRIM,” “LOW EQ,” “MID FREQ,”
“MID EQ,” and “HIGH EQ.”
(All OSCs)
Bypass [Off, On]
When Bypass is checked, all of the EQ will be disabled,
including the Input Trim.
Bypass can be convenient for comparing the results of
the EQ with the original signal.
Input Trim [00…99]
This adjusts the level of the signal going into the EQ. A
setting of 50 corresponds to –6 dB, and a setting of 25
corresponds to –12 dB.
High settings of the Low, Mid, and High Gain controls
can cause substantial increases in the overall level. You
can compensate for this by turning down the input
trim.
(Freq Response Graphic)
Low Gain [–18.0…+00.0…+18.0dB]
This controls the gain of the 80Hz Low Shelf EQ, in
increments of 0.5dB.
Mid Frequency
[100…500 (10Hz step) … 1.0k (20Hz step) …
2.0K (50Hz step) … 10.0k (100Hz step)]
This sets the center frequency for the Mid sweep EQ.
Mid Gain [–18.0…+00.0…+18.0dB]
This controls the gain of the Mid Sweep EQ, in
increments of 0.5dB.
High Gain [–18.0…+00.0…+18.0dB]
This controls the gain of the 10kHz High Shelf EQ, in
increments of 0.5dB.
4–1a
4–1PMC