Filter
Top Products
Sequencer P5: Pattern/RPPR 5–3: RPPR Setup
493
5–3b: KEY, Keyboard & Assigned
graphics
KEY (Key Select) [C#2…C8]
Specifies the key to which you want to assign an RPPR
pattern.
The following parameters will apply to the key that
you select here.
This can also be selected by holding down the ENTER
switch and playing a note on the keyboard.
Keyboard & Assigned graphics
This shows the selected key, and the keys to which a
pattern has been assigned by the RPPR function. See
diagram below.
5–3c: RPPR Setup
Note [C#2…C8]
Assign [Off, On]
On (checked): When you playback the key specified by
“KEY,” the pattern selected in Pattern will be
triggered.
Off (unchecked): That key will sound the currently
selected track at the corresponding pitch, just as in
normal Sequencer mode.
Pattern Bank [Preset, User]
Pattern [P000…149, U00…99]
Selects the RPPR pattern for the key selected in “KEY.”
If the selected user pattern contains no musical data,
there will be no sound when you press that key.
Track [MIDI Track 01…MIDI Track16]
Selects the track that will be used for the RPPR pattern
selected for the “KEY.” When you play the key, the
pattern will be played according to the settings of the
track you select here. You can make track settings in
the P0: Play/REC–P3: MIDI Filter pages.
When you record in realtime with the RPPN function
turned on, the data will be recorded on the track you
select here. For details, see “Using RPPR (Realtime
Pattern Play/Record)” on page 112.
“Information” shows the bank, name, and number of
the program that’s selected for Track.
Mode [Once, Manual, Endless]
Specifies the way in which the pattern assigned to the
specified “KEY” will be played.
Once: When you press the key, the complete pattern
will playback once to the end and then stop.
Manual: The pattern will continue repeating as long as
you continue holding the key, and will stop as soon as
you release the key.
Endless: The pattern will continue repeating even after
you release the key. To stop the pattern playback, press
any note below C2, or press the same key once again.
Shift [–12…+12]
Adjusts the playback pitch of the pattern for the
specified “KEY” in semitone steps over a range of ±1
octave.
With a setting of 0, the pattern will be played at its
original pitch.
Sync [Off, Beat, Measure, SEQ]
Specifies the way in which the pattern playback will be
synchronized when you press the specified “KEY.”
Off: The pattern will begin playing at the moment you
press the note.
Beat: The pattern will synchronize to the beats of the
pattern that was started by the first key (i.e., the first
note-on that occurs from a condition where no notes of
the keyboard are pressed). This setting is suitable
when you wish to play phrase patterns in unison.
Measure: The pattern will synchronize to the measures
of the pattern that was started by the first key. This
setting is suitable for rhythm, bass or drum patterns.
SEQ: The pattern will synchronize to the measures of
the sequencer song.
Non-assignable
keys
Assigned keys and
tracks
Selected key
Key rangeKey range C4
Track of the
selected key
Track selected by
Track Select
Key range shown in the
RPPR Setup List
Once
START STOP
Manual
START STOP
Endless
START STOP
Key-on
Key-off
Same key, or C2
Key-on