Filter
Top Products
Sequencer P2: Track Parameters 2-6: EXi Audio Input
475
2-6: EXi Audio Input
These parameters let you route audio into EXi
instruments which support audio input, such as the
STR-1. You can use this to create feedback loops, or to
process live or recorded audio through the EXi’s
synthesis engine.
EXi which do not support audio input will ignore these
settings.
For more information on using audio inputs with the
STR-1, see “4-8c: Feedback” on page 257.
2–6a: EXi 1
Input Source [PRG, Off, Audio Input 1/2...3/4,
S/P DIF Input L/R, L/R Output,
Indiv. Output 1/2...7/8, REC 1/2, 3/4,
FX Control 1, 2, IFX 1...12, MFX 1, 2, TFX 1, 2]
This selects the input source for EXi1. You can use this
to create a feedback loop, if desired.
PRG uses the setting stored in the Program. You may
find this convenient if you use Program Change
messages to switch between two EXi Programs, and
wish to have the input enabled for one, but disabled
for the other. For more information, see “4–2: EXi
Audio Input” on page 162.
Off disables the input.
Audio Input 1/2…3/4 and S/P DIF Input L/R use the
live audio from the selected input.
L/R Output and Indiv. Output 1/2…7/8 use the audio
as it is heard from the selected output (like connecting
a cable from the output back to the input).
REC 1/2…3/4 and FX Control 1, 2 use the audio from
the selected bus.
IFX 1…12, MFX 1, 2, and TFX 1, 2 use the output of the
selected effect.
Channel Select [Stereo/L+R, Left, Right]
Stereo/L+R: This selection routes a stereo signal to EXi
with stereo inputs, and an L+R summation to EXi with
mono inputs.
Left, Right: This uses only a mono signal from the
selected channel.
2–6b: EXi 2
EXi 2 has the same controls as EXi 1, above.
2–6a
2–6b
2–6PMC
1–1a
1–1b