Filter
Top Products
Global mode
682
Global: Page Menu Commands
Write Global Setting
This command writes Global mode settings (except for
Drum Kits and Wave Sequences).
1. Select Write Global Setting to open the dialog box.
2. To write the data, press the OK button. To cancel
without writing, press the Cancel button.
You can also use the SEQUENCER REC/WRITE
switch to write data in the same way as the Write
Global Setting command.
Press the SEQUENCER REC/WRITE switch to
access the “Update Global Setting” dialog box, and
press the OK button to write the data.
Note: To write a Drum Kits or Wave Sequences,
execute the appropriate page menu command.
(t: “Write Drum Kits,” s: “Write Wave Sequences”)
Set Program User-Bank Type
This specifies the bank type for Program mode
program banks USER-A through G. When you execute
this, the programs within the bank will be initialized to
programs of the specified bank type.
Before you execute, uncheck Program in “Memory
Protect” (0–1e). If you execute with this item still
checked, a message of “Memory Protected” will
appear, and the data will not be loaded.
1. Choose “Set Program User-Bank Type” to open the
dialog box.
This indicates the current type for each user bank.
2. Specify the bank type for each bank.
No Change: The bank type will not be changed. The
data will remain unchanged.
HD-1: The bank type will be set to HD-1.
EXi: The bank type will be set to EXi.
Note: If you execute with a setting other than No
Change, all data in that bank will be initialized –
even if you have specified the same bank type as
before. If you want to keep your data, you must first
use “Save All” or “Save PCG” to save it.
3. Press the OK button to execute, or press the Cancel
button to cancel. A dialog box will ask you to
confirm the operation.
4. Verify the settings. Then press the OK button to
execute, or press the Cancel button to cancel.
Change all bank references
This command changes all program banks specified
for timbres in combinations or tracks of songs.
1. Select “Change all bank references” to open the
dialog box.
2. If you wish to change bank references for
combinations, check “Combination.”
If you wish to change bank references for songs,
check Song.
3. In “Program Bank,” specify the replacement for
each bank.
4. To execute the Change All Bank References
command, press the OK button. To cancel, press
the Cancel button.
If you change two or more different banks to the
same bank, it will not be possible to use this
function to change them back to different banks. Be
careful that the change destination banks do not
overlap.
Touch Panel Calibration
If input via the LCD screen does not work as you
expect, or if the edit cell moves to a location other than
where you pressed the LCD screen, use this command
to adjust the sensitivity of the LCD screen.
1. Select “Touch Panel Calibration” to open the
dialog box.