Filter
Top Products
Program mode: HD-1
120
phrase will loop (e.g., D-D-C-C, D-D-C-C, D-D-C-
C, …). (☞ “Retrigger Each Time” on page 115)
4. “Start Seed”: any value, “Freeze Loop Length”:
1…32
The same phrase will play each time you trigger the
GE. That phrase will loop for the number of
measures you specified in “Freeze Loop Length.”
For example if you select a program or combination,
and make these settings for a KARMA Module that
generates random changes each time it is triggered,
the exact same phrase will loop every time. The
phrase that is looped will be different if you change
the “Start Seed” value. For example, suppose there
is a GE that, if you input C-D-E-F, will randomly
vary the order of notes, and repeatedly play four
notes in each measure. If you set “Freeze Loop
Length” to 1 (measure) and trigger this GE, the
same four notes will loop (e.g., D-E-E-C, D-E-E-C,
D-E-E-C, …). Even if you trigger the GE again, the
same phrase (D-E-E-C, D-E-E-C, D-E-E-C, …) will
be reproduced. If you change the “Start Seed” value,
a different phrase (e.g., C-C-E-E, C-C-E-E, C-C-E-E,
…) will loop. (☞ “Retrigger Each Time” on
page 115)
Retrigger Each Time [Off, On]
When set to On (checked), every time the specified
loop length is completed, the Phase Pattern,
Envelopes, and Indexes will retrigger as if the
keyboard itself was retriggered. This means that the
notes in the phrase will be restarted according to the
Note Trigger settings (☞ “Note Trigger” on page 109)
and the applicable internal settings of the GE, and any
envelopes will be retriggered according to the
Envelope Trigger/Latch settings (☞ “Envelope
Trigger” on page 109, “Envelope Latch” on page 109)
When Off (unchecked), the overall length of the
internal GE Phase Pattern controls when the loop will
be retriggered. For example, if the Phase Pattern is 8
bars, and the “Freeze Loop Length” is set to 2 bars,
then the randomizations will reset every 2 bars
(controlling the rhythm and movement of notes, for
example), but the melody and envelopes may not
trigger from the beginning until every 8 bars is
completed. (☞ “Checking the Freeze Randomize
function, and performing “Capture Random Seed”” on
page 148)
Not available unless “Freeze Loop Length” is set to
something other than Off (unchecked).
Note: In some cases, the two settings may sound the
same, depending on the internal settings of the GE.
▼ 7-8: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy KARMA Module. For more information,
see “Copy KARMA Module” on page 146.
• 3: Initialize KARMA Module. For more
information, see “Initialize KARMA Module” on
page 147.
• 4: Copy Scene. For more information, see “Copy
Scene” on page 147.
• 5: Swap Scenes. For more information, see “Swap
Scene” on page 147.
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 147.