Filter
Top Products
Total Effects (TFX1, 2) In/Out
753
Total Effects (TFX1, 2)
In/Out
The total effects TFX1 and TFX2 are stereo-in and
stereo-out. The Dry (unprocessed) side of the Wet/Dry
parameter sends the stereo input sound directly to the
stereo output. The way in which the Wet (processed)
side is output depends on the type of effect, as follows.
Mono–Mono Parallel
141: P4EQ//P4EQ-185: Mt.BPM Dly//Mt.BPM Dly
For details, see “Mono–Mono Parallel Effects” on
page 734.
If you select 000:No Effect, the stereo input will be
passed to the stereo output without any processing.
You can switch the effects on/off using the MFX1 or 2
ON/OFF buttons or the P9 - Routing settings in each
mode. When off, the effect will be bypassed. The stereo
input will be passed to the stereo output without any
processing, just as if 000:No Effect is selected.
Separately from this ON/OFF button, MIDI control
change CC#95 can be received to turn TFX1 and
TFX2 off. A control change value of 0 turns them off,
and a value of 1–127 restores them to the prior
setting. You can also use “Effect Global SW” to turn
off TFX1 and TFX2 in the same way. This is
controlled on the global MIDI channel.
Routing
The total effects TFX1 and TFX2 are placed
immediately before the AUDIO OUTPUT (MAIN)
L/MONO and R outputs. Both effects (TFX1 and 2) are
available in all modes.
If the Bus Select setting for an oscillator
(Program/Sampling modes), timbre (Combination
mode), track (Sequencer mode), or audio input (in all
modes) or the post-insert Bus Select is set to L/R, the
signal will be output from the AUDIO OUTPUT
(MAIN) L/MONO and R jacks.
The sound from MFX1 and 2 is routed through TFX1
and TFX2, and then output to AUDIO OUTPUT
(MAIN) L/MONO and R.
Stereo In - Stereo Out
Mono In - Mono Out
Mono In - Stereo Out
Effect
Effect
Effect
+
Effect
+
Wet