Filter
Top Products
Sequencer mode
514
8–4: Audio Routing2
Here you can specify the buses, effect control bus, and
REC bus for the outputs of audio tracks 1–16.
8–4a: Audio Routing2
Track 01 (Tack Number)
STEREO
This is shown if “Stereo Pair” is on.
Bus Select (IFX/Indiv.Out Assign)
[L/R, IFX1…12, 1…8, 1/2…7/8, Off]
This specifies the bus for the audio track. The current
settings can also be viewed in the Routing Map. This
parameter can also be edited from the P8– Audio
Routing 1 page. For more information, please see “Bus
Select (IFX/Indiv.Out Assign)” on page 510.
FX Control Bus [Off, 1, 2]
Sends the output of the audio track to an FX Control
bus (two-channel stereo FX Ctrl 1 or 2).
For more information, please see “FX Control Bus” on
page 511. For examples, see “FX Control Buses” on
page 730.
REC Bus [Off, 1, 2, 3, 4, 1/2, 3/4]
These settings send the output of the audio track to the
REC buses (four mono channels: 1, 2, 3, 4). For more
information, please see “REC Bus (All OSCs to)” on
page 511.
Track 02…16 (Track Number)
Here you can specify the output bus, effect control bus,
and REC bus for audio tracks 2 through 16. These are
the same as for track 1. See “Track 01”:.
▼ 8–4: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Memory Status. For more information, see
“Memory Status” on page 524.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy Insert Effect. For more information, see
“Copy Insert Effect” on page 149.
• 3: Swap Insert Effect. For more information, see
“Swap Insert Effect” on page 150.
• 4: Stereo Pair. For more information, see “Stereo
Pair” on page 528.
• 5: Put Effect Setting To Track. For more
information, see “Put Effect Setting to Track” on
page 557.
• 6: FF/REW Speed. For more information, see
“FF/REW Speed” on page 525.
• 7: Set Location (for Locate Key.) For more
information, see “Set Location (for Locate Key)” on
page 525.
1–1a
1–1b
8–1a
8–4a
8–4PMC