Filter
Top Products
Combination mode
364
Off (unchecked): The scale specified by Scale (2–3b)
will be used.
Timbres 02…16
These are the pitch-related settings for timbres 2
through 16. The settings are the same as for timbre 1.
For more information, see “Timbre 01”.
2–3b: Combination’s Scale
This specifies the scale that the combination will use.
For more information, please see “1–1g: Scale” on
page 36.
Type (Combi’s Scale) [Equal Temperament…User
Octave Scale15]
Selects the scale.
Key [C…B]
Selects the tonic key of the selected scale.
Random [0…7]
As this value is increased, an increasingly random
deviation will be added to the pitch at each note-on.
If Status (0–1b, 2–1a) is INT, this setting will affect
the pitch produced by the OASYS. If Status is EXT,
this setting will affect the note number of the note
messages transmitted via MIDI.
▼ 2–3: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy From Program. For more information, see
“Copy From Program” on page 405.
• 3: Detune BPM Adjust. For more information, see
“Detune BPM Adjust” on page 408.
2–4: Delay
This specifies the time (delay) from when the timbre
receives a note-on until the sound begins.
2–4a: Delay
Timbre 01
Mode [Time, Tempo]
Chooses the unit in which you will specify delay time.
Time: Specify the delay time in units of milliseconds
(ms = 1/1000th of a second).
Tempo: Specify the delay time in terms of a Base Note
and Times relative to the Tempo. For example if Base
Note = , Times = 01, and Tempo = 60 BPM, the delay
time will be equivalent to 1000 ms.
2–4a
2–4PMC
1–1a
1–1b