Filter
Top Products
Combination P2: Timbre Parameters 2–5: Wave Sequence/KARMA
365
Time [ms] [0000…6000ms, KeyOff]
Specifies the time (delay time) from note-on until the
timbre begins to produce sound, in units of ms
(1/1000th of a second). This setting is available if
“Mode” is set to Time.
KeyOff: The note will begin sounding at note-off. In
this case, the sound will not die away if the sustain
level of the program’s amp EG is other than 0. This
setting is used when creating harpsichord sounds.
Normally you will set this to 0000.
Base Note [ , , , , , , , , , ]
Times [01…32]
This setting is available when “Mode” is set to Tempo.
It specifies the time (delay time) from note-on until the
timbre begins to produce sound, in terms of a note
value relative to the “Tempo ( )” (0–1a).
Use Base Note to specify the desired note value, and
use Times to extend that note value by the specified
multiple.
For example if you set Base Note to a quarter note ( )
and Times to 02, that timbre will sound with a delay of
a half note ( ). Even if you change “Tempo ( )” (0–1a),
the delay time will always be a half note ( ). If you use
these parameters to specify a delay of a half note ( ). In
this case, a Tempo of 60.00 BPM will produce a 2000
ms delay, and a Tempo of 120.00 BPM will produce a
1000 ms delay.
Timbres 02…16
These are the delay time settings for timbres 2 through
16. They are the same as for timbre 1. See “Timbre 01”.
▼ 2–4: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy From Program. For more information, see
“Copy From Program” on page 405.
2–5: Wave Sequence/KARMA
Here you can make settings related to wave sequence
and KARMA functionality for each timbre.
2–5a: Wave Sequence/KARMA
Timbre 01
Wave Sequence Key Sync [PRG, Off, On]
Specifies the wave sequence Key Sync setting
(Program 1–1e) of the program selected for the timbre.
This setting is valid if the program uses a wave
sequence.
2–5a
2–5PMC
1–1a
1–1b