Filter
Top Products
Combination mode
398
8–6: Track View
8–6a: Track View
Here you can view the timbre output and insert effect
routing.
Used in Tracks
The upper and lower rows of boxes with eight boxes in
each row indicate the timbre that is being sent to the
corresponding insert effect. (The eight upper boxes
correspond to timbres 1–8, and the eight lower boxes
correspond to timbres 9–16.)
In this example you can see that IFX7 and 8 are being
used by timbres 6 and 7, as well as by timbre 1. So, any
changes to these effects will affect all three timbres.
Timbre Select [Timbre 01…Timbre 16]
Here you can select the timbre that will be shown in
the Track View screen.
The lower line shows the program name and MIDI
channel of the timbre.
The screen shows the insert effect(s) used by the
selected timbre.
Slot [IFX1…IFX12]
This indicates the slot number, effect type, effect on/off
status, and control channel for the chained insert
effects.
The selected slot is shown in dark blue. In the
“Selected” area below, you can specify the “Effect
Type” and “On/Off” status of the selected effect slot.
This is also the effect slot that will be affected by the
page menu commands “Insert IFX Slot” and “Cut IFX
Slot.”
When you move from this page to the P8– IFX1-12
page, the IFX you selected here will be selected.
For example if you select Timbre 03, only the insert
effects used by timbre 3 will be shown.
“OUTPUT” indicates the Bus Select settings that follow
the insert effect. This tells you the output destination to
which the audio signal will be sent.
8–6b: Selected
Here you can specify the “Effect Type” and “On/Off”
status of the insert effect slot selected by Track Select.
(“8–6a: Track View,” above)
▼ 8–6: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy Insert Effect. For more information, see
“Copy Insert Effect” on page 149.
• 3: Swap Insert Effect. For more information, see
“Swap Insert Effect” on page 150.
8–6PMC
8–6a
8–6b