Filter
Top Products
Program mode: HD-1
116
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 147.
7–7: Dynamic MIDI
Dynamic MIDI lets you use this instrument’s
controllers and MIDI control messages to control
specific KARMA functions.
You can take advantage of this to control KARMA in
various ways while you play. For example, you can use
note-ons to advance the KARMA clock (Manual
Advance), or a joystick to Trigger the start of the
patterns. You can use a foot pedal to control Auto
Transpose, or a damper pedal to control the KARMA
Latch settings.
7–7a: Program Name and Tempo
For descriptions of these parameters, please see “7–2a:
Program Name and Tempo” on page 100.
7–7b: Dynamic MIDI
You can set up 8 different Dynamic MIDI routings,
each of which has an identical set of parameters, as
described below.
Dynamic MIDI 1…8
Input (Input Module) [A]
In Program mode this is fixed at A. This is because only
KARMA Module [A] is used. This setting cannot be
changed.
Source [Off, JS+Y (CC#01)
…Velocity Outside Zone]
Indicates the controller or action. that will be the
Dynamic MIDI source. For more information, see
“Dynamic MIDI Sources & Destinations” on page 984.
Bottom (Range Bottom) [000…127]
Specifies the lower limit for the value controlled by
Source. If Source is Short Note, Note No., White Note,
or Black Note, the numeric value corresponds to the
note numbers C-1–G9.
Top (Range Top) [000…127]
Specifies the upper limit for the value controlled by
Source. If Source is Short Note, Note No., White Note,
or Black Note, the numeric value corresponds to the
note numbers C-1–G9.
Action (Source Action) [Momentary, Toggle,
Continuous]
Specifies the operation mode for Dynamic MIDI.
Momentary: The parameter will be controlled as a
momentary switch. For example if Source is JS+Y
(CC#01), the parameter will normally be off, and will
be on when you move the joystick.
Note: If Polarity is + and the source controller value is
less than or equal to the Bottom setting, the destination
will be off. If the controller value is greater than or
equal to the To p setting, it will be on.
Example
When Bottom: 000 and Top : 127
7–7PMC
7–7b
7–7a