Filter
Top Products
Appendices
1026
Sample used in other multisample(s)
Continue?
Meaning: The sample you are editing is used by other
multisamples. To continue editing, press the OK
button.
Selected file/path is not correct
Meaning: When loading a divided .PCG file, you
attempted to load a .PCG file of the same name that
was not divided or had differing contents.
• Load the correct .PCG file.
Meaning: When loading a KSF file that was split across
multiple media, the order in which you attempted to
load the files was incorrect.
• Load the KSF file in the correct order. To view the
file number order in which the KSF files were
saved, you can check the Translation page menu
command. (The sample name and number of the
first KSF file will be displayed.)
Slice point over limit
Can’t divide
Meaning: When using the Sampling mode Time Slice
or Time Stretch commands, the Slice setting would
divide the sample into more samples than the
maximum possible number (1000), and thus Divide
cannot be executed.
• Use Link to connect any Index that you do not
require, and then execute Divide.
Source file is not 44100Hz or 48000Hz
Can’t convert
Meaning: When executing the Disk mode Utility page
menu command Rate Convert, you selected a WAVE
file of a sampling rate other than 44.1 kHz, 48 kHz.
• You cannot convert WAVE files other than 44.1
kHz or 48 kHz.
Source IFX is all empty
Meaning: This message will appear when you execute
Copy Insert Effect or Copy From Program if there is no
insert effect to be copied.
Source is empty
Meaning: No data exists in the track or pattern that
you specified as the source.
• Specify a track or pattern that contains musical
data.
Source sample is empty
Meaning: When executing Insert, Mix, or Paste, the
source sample is empty.
• Execute the Copy operation before executing Insert,
Mix, or Paste.
T (The clock–Track)
The clock battery voltage is low. Please
replace the battery, and set the date and
time in Disk mode.
Meaning: The battery for the clock/calendar function
has run low. To solve this problem:
• Replace the battery as described in “Installing the
calendar battery” on page 1040. Then use the Disk
Utility page menu command “Set Date/Time” to
set the correct date and time.
The Expansion Sample Setup has now
been changed. In order for your changes
to take effect, please turn the power off,
and then on again. [OK]
Meaning: This will appear when you’ve changed
settings in the Global P0 page menu command
“Expansion Sample Setup.” Turn off the power switch,
and then turn it on again to start up the system. The
expansion samples you chose will become available.
There are un-saved audio files from your
previous recording session.
Do you want to restore these files, or
delete them from the disk?
[Restore] [Delete]
Meaning: The WAVE files created when you recorded
audio tracks before powering-off were not saved as
song data, and remain in the TEMP folder of the
internal hard disk. Since the data was not saved as
song data, all audio events and region data were
deleted, but if necessary you can save these WAVE files
and use them to create a new song.
• If you want to keep this data, press Restore. If you
want to delete this data, press Delete.
There is not readable data
Meaning: Either the file size is 0 or the file does not
contain data that can be accessed by the load or open
operation. Alternatively, the data is damaged etc., and
cannot be loaded or accessed.