Filter
Top Products
Sampling P9: Master/Total Effect 9–1: Routing
611
Sampling P9: Master/Total Effect
Here you can select the effect types for the master
effects and total effects, and turn them on/off.
The master effects are output to the L/R bus. The total
effects are inserted in the L/R bus. If you want to use
these while sampling, set Source Bus to L/R.
For more information, please see the “Effect Guide,”
beginning on page 727.
Note: When you sample, MFX1 On/Off, MFX2 On/Off,
TFX1 On/Off, and TFX2 On/Off are automatically
turned off. This is done so that the effect will not be
applied again (i.e., a second time) when you play back
the sample that was resampled with the MFX1/2 and
TFX1/2. (In the same way, the Bus Select (All OSCs
to) parameter will automatically be set to L/R.) Be
aware of this if you want to sample once again.
9–1: Routing
9–1a: MFX
The master effect does not output the direct sound
(Dry). Adjust the “Return 1” and “Return 2” return
levels to return the signal to the L/R bus and mix it
with the L/R bus signal.
The master effects are stereo-in/out, but depending on
the selected effect type, the output may be monaural.
See “In/Out” on page 734.
MFX1
MFX1 [000…185]
This selects the effect type for master effect 1. Choose
from 000:No Effect – 185: Mt.BPM Dly // Mt.BPM Dly.
If you choose 000:No Effect, the output from the master
effect is muted.
Category/MFX Select menu
When you press the popup button, the Category/MFX
Select menu will appear, letting you select effects by
category. Use the tabs to select a category, and then
select an effect within that category. Press the OK
button to execute your selection, or press the Cancel
button to cancel.
MFX1 On/Off [Off, On]
Switches the master effects 1 on/off. When off, the
output will be muted. This will alternate between on
and off each time it is pressed.
Separately from the settings here, you can use
control change #94 to turn master effects 1 and 2 off.
A value of 0 turns them off, and values of 1–127
restore the original setting. The global MIDI channel
specified by MIDI Channel (Global 1–1a) is used
for this message.
Return 1 [000…127]
This specifies the return level from the master effect to
the L/R bus (after which it passes through TFX1 and 2,
and is sent from L/MONO and R).
9–1b
9–1a
9–1c
9–1PMC8–5b