Filter
Top Products
Delay 087: Reverse Delay
837
BAND4 LFO
Band 4’s LFO has the same parameters as the “BAND1
LFO,” above.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
087: Reverse Delay
This is a delay that plays back the input signal in
reverse. You can also continue feedback while
alternating playing the signal in reverse and forward
directions.
INPUT
Input Level Dmod [%] [+/–100]
Sets the modulation amount of the input level.
Source [Off…Tempo]
Selects the modulation source for the input level.
REVERSE DELAY
Reverse Time [msec] [0…900]
Sets the length of reverse playback (= delay time).
p.837.
Level [0…100]
Sets the output level of the reverse playback.
L Post-Delay Time [msec] [0…900]
Sets the delay time of the Left Tap.
Level [0…100]
Sets the output level of the Left Tap.
R Post-Delay
Time [msec] [0…900]
Sets the delay time of the Right Tap.
Level [0…100]
Sets the output level of the Right Tap.
Feedback Mode [Reverse, Reverse/Forward]
Reverse: the feedback plays in reverse.
Reverse/Forward: the feedback alternates between
playing backwards and forwards, as shown below.
Feedback [+/–100]
Sets the feedback amount.
Source [Off…Tempo]
Selects the modulation source of feedback amount.
Amount [+/–100]
Sets the feedback amount.
High Damp [%] [0…100]
Sets the damping amount in the high range.
Sync Source [Off…Tempo]
Selects the modulation source that will reset the point
at which the sound is captured for reverse playback.
p.837.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
REVERSE DELAY: Reverse Time and Sync Source
The sound will be played in reverse for the duration
specified by Reverse Time. You can reset the dividing
point for reverse playback by specifying a modulation
source for Sync Source.
+
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
D
-mod
Trigger
Reverse
High DampTrim
Level
Feedback
Feedback
Feedback Mode
Delay
Sync
Feedback Mode
Input
wet
wet
Feedback Mode: Revese
Time
Feedback Mode: Revese/Forward
Reverse Time/Sync
Input
wet
Time
Reverse Time
Sync
reset
Reverse Time