Filter
Top Products
Program mode: HD-1
110
For Sus2 and Rel2, the envelope will continue
repeating even if the key is released.
▼ 7-4: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy KARMA Module. For more information,
see “Copy KARMA Module” on page 146.
• 3: Initialize KARMA Module. For more
information, see “Initialize KARMA Module” on
page 147.
• 4: Copy Scene. For more information, see “Copy
Scene” on page 147.
• 5: Swap Scenes. For more information, see “Swap
Scene” on page 147.
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 147.
7–5: GE Real-Time Parameters
Here you can edit the Real-Time parameters of the GE
selected for the KARMA Module. By assigning GE
parameters to KARMA Real-Time Controls, you can
control the phrase or pattern in real-time while you
play.
7–5a: GE Number & Name, RTC Select,
and Tempo
GE Number & Name
[0000: Arp Model 01 Up/Dn…
2047: Tempo Env Repeats]
This shows the GE selected for the Module. For more
information, please see “0–6b: GE Select” on page 8.
GE RTC Select [1–16, 17–32]
This switches the GE realtime parameter display.
1–16: GE parameters 1–16 will be displayed.
17–32: GE parameters 17–32 will be displayed.
(Tempo) [40.00…240.00, EXT]
For more information, please see “Tempo” on page 5.
7–5b: GE Real-Time Parameters
GE Parameter 01…32 [Parameter Name]
Each GE has up to 32 preset parameters for controlling
the phrase or pattern, referred to as GE Real-Time
Parameters (or GE RTP). The specific parameters, and
the available value ranges, will vary depending on the
selected GE.
Each of the GE Real-Time Parameters has a basic value,
a controller assignment with polarity, and minimum
and maximum values (for setting the range of the
selected controller). When you select a new GE, the
basic, minimum, and maximum values will be reset to
the values saved in the GE, and the controller
assignment will be set to the defaults for the GE’s RTC
Model.
7–5PMC
7–5a
7–5b