Filter
Top Products
Program mode: HD-1
86
5–1c: Frequency MIDI/Tempo Sync
MIDI/Tempo Sync [Off, On]
On (checked): When MIDI/Tempo Sync is On, the
LFO will synchronize to the system tempo, as set by
either the Tempo knob or MIDI Clock. The LFO speed
will be controlled by the Base Note and Times
parameters, below. All settings for Frequency and
Frequency Modulation will be ignored.
Off (unchecked): When MIDI/Tempo Sync is Off, the
Frequency settings will determine the speed of the
LFO, and the tempo settings will have no effect.
Base Note (Sync. Base Note) [ … ]
This sets the basic speed of the LFO, relative to the
system tempo. The values range from a 32nd note to a
whole note, including triplets.
Times (Sync. Times) [01…32]
This multiplies the length of the Base Note. For
instance, if the Base Note is set to a sixteenth note, and
Times is set to 3, the LFO will cycle over a dotted
eighth note.
▼ 5–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Swap LFO 1 & 2. For more information, see
“Swap LFO 1&2” on page 146.
5–2: OSC1 LFO2
This is Oscillator 1’s second LFO. Its parameters are
exactly the same as those for the first LFO, as described
under “5–1: OSC1 LFO1” on page 83–except that LFO1
cannot modulate LFO2.
5–5: OSC2 LFO1
This page controls Oscillator 2’s first LFO. It is
available only when the Oscillator Mode is set to
Double; if not, the page will be grayed out.
The parameters are identical to those for Oscillator 1,
as described under “5–1: OSC1 LFO1” on page 83.
5–6: OSC2 LFO2
This page controls Oscillator 2’s second LFO. It is
available only when the Oscillator Mode is set to
Double; if not, the page will be grayed out.
Its parameters are exactly the same as those for the first
LFO, as described under “5–1: OSC1 LFO1” on
page 83–except that LFO1 cannot modulate LFO2.