Filter
Top Products
Program P1: Basic/Vector 1–8: Set Up Controllers
45
▼ 1–6: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy Oscillator. For more information, see
“Copy Oscillator” on page 144.
• 3: Swap Oscillators. For more information, see
“Swap Oscillator” on page 144.
• 4: Copy Vector Envelope. For more information,
see “Copy Vector Envelope” on page 144.
1–8: Set Up Controllers
This page lets you set up the functionality of switches 1
and 2 (SW1/2) and Real-Time Knobs 5–8. These
settings are made independently for each Program.
1–8a: Panel Switch Assign
These settings control the functionality of SW1 and
SW2.
SW1 [Off, …, After Touch Lock]
This assigns a function to the SW1 switch. The on/off
status can also be memorized. When you change the
assignment, the switch is set to the Off condition.
For a complete list of the possible assignments, please
see “SW1/2 Assignments” on page 979.
Mode [Toggle, Momentary]
This specifies the mode of on/off when the SW1 switch
is pressed.
Toggle: The state will alternate between On and Off
each time you press the SW1 switch.
Momentary: The state will remain On only while you
continue holding down the SW1 switch.
SW2 [Off, …, After Touch Lock]
Mode [Toggle, Momentary]
This assigns a function to the SW2 switch. The
functions that you can assign to the SW2 switch are the
same as for the SW1 switch, with the exception that the
SW1 switch’s SW1 Mod.:CC#80 assignment is replaced
by SW2 Mod.:CC#81.
1–8b: Modulation Knob Assign
These settings assign functions (mainly MIDI control
changes) to realtime modulation knobs 5–8. For a
complete list of the possible assignments, please see
“Realtime Knobs 5–8 Assignments” on page 980.
The functions you assign here will apply when you
operate realtime modulation knobs 5–8.
1–8PMC
1–8a
1–8b