Filter
Top Products
Global mode
688
CC Default: The parameters will be reset to the
typical settings, including the standard settings for
the pads and the KARMA sliders and switches. The
default values are shown in the table below.
If you want to record KARMA controllers in
Sequencer mode, or use the controllers to control an
external MIDI device, we recommend using this
setting.
(You are also free to assign different MIDI control
change messages to the controllers, if you wish.)
3. Press the OK button to execute the reset command,
or press the Cancel button to cancel.
Reset Controller MIDI Assign Default
Copy Scale
This command copies data from a preset scale or
between user scales. For details on the preset scales,
refer to “Type” (Program 1–1e).
1. Select “Copy Scale” to open the dialog box.
2. Use “From” to select the copy-source scale.
If you select Pure Major or Pure Minor, specify the
“Key” (located at the right) as well.
Stretch cannot be selected if “To” is User All Notes
Scale.
3. In “To,” selects the copy destination scale.
4. To execute the Copy Scale command, press the OK
button. To cancel, press the Cancel button.
Write Wave Sequence
A dialog box for saving a wave sequence will appear.
You can select a new location, and edit the name of the
wave sequence.
You must write an edited wave sequence if you want
to keep it. An edited wave sequence cannot be
recovered if you turn off the power or select a different
wave sequence before writing it.
1. Choose “Write Wave Sequence” to open the dialog
box.
2. The upper line shows the wave sequence name. If
you want to edit the wave sequence name, input
the desired name in the text edit box.
3. Use the lower line “To Wave Sequence” to select
the writing-destination.
You can also press the popup button and choose the
writing-destination from the “Wave Sequence
Select” menu. If you select the “Wave Sequence
Select” menu, press the OK button to confirm or
press the Cancel button to cancel your selection.
4. Press the OK button to execute the Write Wave
Sequence command, or press the Cancel button to
cancel without executing.
Note: You can also use the SEQUENCER REC/WRITE
switch to write in the same way as the “Write Wave
Sequence” command. Press the SEQUENCER
REC/WRITE switch to access the Update Wave
Sequence dialog box, and write the wave sequence. In
this case, the data will be written to the currently
selected wave sequence.
OASYS Controls CC Default Default Setting
KARMA
ON/OFF CC#14
Off
SCENE CC#30
LATCH CC#31
KARMA
Sliders
1 CC#22
2 CC#23
3 CC#24
4 CC#25
5 CC#26
6 CC#27
7 CC#28
8 CC#29
KARMA
Switches
1 CC#102
2 CC#103
3 CC#104
4 CC#105
5 CC#106
6 CC#107
7 CC#108
8 CC#109
Pads
1 CC#110
2 CC#111
3 CC#112
4 CC#113
5 CC#114
6 CC#115
7 CC#116
8 CC#117
Vector
Joystick
VJS X CC#118 CC#118
VJS Y CC#119 CC#119