Filter
Top Products
Sampling P8: Insert Effect 8–9: Common FX LFO
609
8–7b: IFX2…12
Here you can edit the parameters of the insert effects
selected in the P8– Insert FX page.
The parameters for IFX2–IFX12 are the same as for
IFX1. See “8–7b: IFX2…12,” above.
▼ 8–7: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Copy Insert Effect. For more information, see
“Copy Insert Effect” on page 149.
• 1: Swap Insert Effect. For more information, see
“Swap Insert Effect” on page 150.
• 2: Write FX Preset. For more information, see
“Write FX Preset” on page 154.
8–9: Common FX LFO
The two Common FX LFOs allow you to synchronize
LFO-based modulation for multiple effects, such as
phasers, flangers, filters, and so on.
The Common LFOs control only the frequency, MIDI
synchronization, and reset options; each individual
effect still has its own settings for the LFO waveform
and phase.
Within the individual effects, you can choose whether
to use one of the Common LFOs, or to use the
individual effect’s frequency, sync, and/or reset
settings instead. This is done via the effect’s LFO Type
parameter; select Individual to use the effect’s settings,
or Common 1 or 2 to use the Common LFOs.
Dmod (Dynamic Modulation) is controlled on the
global MIDI channel specified in Global mode P1.
(Tempo) [040.00…240.00, EXT]
This specifies the tempo. This setting is used for
controlling effects, etc.
8–9a: Common FX LFO1
Frequency [0.02…20.00 (Hz)]
Sync (Reset) [Off, On]
Src (Dmod Src) [List of Dmod Sources]
MIDI/Tempo Sync [Off, On]
BPM [MIDI, 040.00…240.00]
Base Note [ , 3 , , 3 , , 3 , , 3 , , ]
Times [01…32]
These parameters are the same as in Program mode.
See “8–9a: Common FX LFO1” on page 132.
8–9b: Common FX LFO2
The parameters are identical to those for Common FX
LFO1.
8–9a
8–9b
8–9PMC