Filter
Top Products
EXi: AL-1 Analog Synthesizer
190
Please take these names as suggestions, rather than
restrictions. If you like, you’re free to use these EGs to
control any EG or AMS destination, or to use other EGs
to control Filter Frequency and Pitch.
Velocity Intensity [–99…+99]
This lets you use velocity to scale the amount of the EG
applied to Filter A.
EG Intensity [–99…+99]
This controls the initial effect of the EG on Filter A’s
cutoff frequency, before any velocity or AMS
modulation.
AMS [List of AMS Sources]
This selects an AMS modulation source to scale the
amount of the EG applied to Filter A.
For a list of AMS sources, see “AMS (Alternate
Modulation Source) List” on page 967.
Intensity [–99…+99]
This controls the depth and direction of the AMS
modulation.
Filter B
The EG parameters for Filter B are the same as those
for “Filter A,” above.
When Link is On, or when the Filter Routing is set to
Single or 24dB/oct, all of these parameters are grayed
out.
5–3c: Filter Modulation
Filter A Frequency
AMS 1 [List of AMS Sources]
This selects the first modulation source to control Filter
A’s Frequency. For a list of AMS sources, see “AMS
(Alternate Modulation Source) List” on page 967.
Intensity [–99…+99]
This controls the depth and direction of the Frequency
modulation.
Intensity Mod AMS [List of AMS Sources]
This selects an AMS source to modulate the intensity of
AMS 1.
Intensity [–99…+99]
This controls the depth and direction of the Intensity
Mod AMS.
AMS 2 [List of AMS Sources]
This selects a second modulation source to control
Filter A’s Frequency. For a list of AMS sources, see
“AMS (Alternate Modulation Source) List” on
page 967.
Intensity [–99…+99]
This controls the depth and direction of AMS 2.
Filter B Frequency
The settings for Filter B are the same as those for “Filter
A Frequency,” above.
When Link is On, or when the Filter Routing is set to
Single or 24dB/oct, all of these parameters are grayed
out.
▼ 5–3: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.