Filter
Top Products
Combination mode
366
PRG: The setting of the program is used.
Off: Key Sync is forced off. The wave sequence of each
note will synchronize to the same step.
On: Key Sync is forced on. The wave sequence will
start each time you press a key. If the wave sequences
have differing steps or rates, they will proceed
independently.
Wave Sequence Swing[%] [PRG, –300…+300]
Specifies the wave sequence “Swing%” setting
(Program 1–1e) of the program selected for the timbre.
This setting is valid if the program uses a wave
sequence.
PRG: The setting of the program is used.
–300…+300: The Swing% specified here is used
regardless of the program’s “Swing” setting.
For more information, please see “Swing” on page 35.
Wave Sequence Quantize Trigger [PRG, Off, On]
This allows you to override the Program’s Wave
Sequence “Quantize Trigger” setting (Program 1–1d).
If you’re using multiple Programs with rhythmic Wave
Sequences, you can use this to synchronize all of the
Wave Sequences at note-on.
Note that Quantize Trigger applies only when the
Wave Sequence’s Mode is set to Tempo. For more
information, see “Mode” on page 664.
PRG: The setting of the program is used.
Off: “Quantize Trigger” is forced off. The wave
sequence will trigger immediately after note-on.
On: “Quantize Trigger” is forced on. The wave
sequence pattern will synchronize to eighth-note
timing of the currently-sounding wave sequence; i.e.,
the trigger will be quantized.
For more information, please see “Quantize Trigger”
on page 36.
KARMA Timbre Off Control
[Normal, Timbre Off by KARMA Off, Timbre Off
by KARMA On]
Nrm (Normal): The KARMA ON/OFF switch will not
control whether a timbre will sound. Normally you
will select Normal.
by Off (Timbre Off by KARMA Off): The timbre will
sound as usual when the KARMA ON/OFF switch is
on.
The timbre will not sound when the KARMA ON/OFF
switch is off.
Use this when you want a specific timbre of multiple
timbres set to the same MIDI channel to be silent only
when KARMA is off.
by On (Timbre Off by KARMA On): The timbre will
not sound when the KARMA ON/OFF switch is on.
The timbre will sound as usual when the KARMA
ON/OFF switch is off.
Use this when you are using a KARMA Module to
control multiple timbres that are set to the same MIDI
channel, and want a specific timbre to be silent only
when the KARMA function is on.
For example you can use this to play a two-timbre
layer from the keyboard when KARMA is off, and use
one timbre to sound the phrase when KARMA is on.
If the Status (0–1b) of each timbre is INT, you can use
the Timbre Off Control setting to stop the oscillator of
each timbre from sounding.
Timbres 02…16
These are the wave sequence and KARMA-related
settings for timbres 2 through 16. They are the same as
for timbre 1. See “Timbre 01”.
▼ 2–5: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy From Program. For more information, see
“Copy From Program” on page 405.