Filter
Top Products
Sequencer mode
508
7–9: Name/Note Map
Here you can assign the names for KARMA SLIDERS
1-8 and KARMA SWITCHES 1-8, view Global Note
Map Tables, and edit the Custom Note Map Table
stored with the Sequence.
7–9a: Name
Master, Module A…D
Each Module Control layer has its own set of names for
each of the KARMA SLIDERS and SWITCHES. For
more information, see “7–9b: Module A” on page 121.
Slider1…8 [000 (no name)…
571 Waveform Select [16]]
Switch1…8 [000 (no name)…
571 Waveform Select [16]]
7–9b: Note Map (Custom)
Table [Custom, Global 1…64]
In (Note In) [C–1…G9]
Out (Note Out) [Remove, C–1…G9]
Octave Replicate [Off, On]
Reset [button]
Please see “7–9c: Note Map” on page 121..
▼ 7–9: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Memory Status. For more information, see
“Memory Status” on page 524.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy KARMA Module. For more information,
see “Copy KARMA Module” on page 408.
• 3: Initialize KARMA Module. For more
information, see “Initialize KARMA Module” on
page 409.
• 4: Copy Scene. For more information, see “Copy
Scene” on page 409.
• 5: Swap Scene. For more information, see “Swap
Scene” on page 409.
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 409.
• 7: Auto Assign KARMA RTC Name. For more
information, see “Auto Assign KARMA RTC
Name” on page 409.
• 8: FF/REW Speed. For more information, see
“FF/REW Speed” on page 525.
• 9: Set Location (for Locate Key). For more
information, see “Set Location (for Locate Key)” on
page 525.
• 10: Copy From Program. For more information, see
“Copy From Program” on page 526.
1–1a
7–9a
7–9b
7–9PMC